2
DO337-1
P2036 and P2056 User's Guide
Pico Technology
EC declaration of conformity
Pico Technology declares that the following products comply with the requirements of the specified
Directives and Standards as listed below. Technical documentation required to demonstrate
compliance to the standards is available for inspection by the relevant enforcement authorities.
Products carry the CE mark.
Products covered by this declaration:
P2036
300 MHz 10:1 oscilloscope probe
P2056
500 MHz 10:1 oscilloscope probe
EU Directives covered by this declaration:
2014/35/EU
Low Voltage Equipment Directive
2012/19/EU
Waste Electrical and Electronic Equipment
2011/65/EU
Restriction of use of certain Hazardous Substances
The basis on which conformity is being declared:
EN61010-1:2010
Safety requirements for electrical equipment for measurement, control and
laboratory use, general equipment requirements.
EN61010-031:2015
Safety requirements for hand-held probe assemblies for electrical measurement
and test.
RoHS and WEEE
Manufacturer’s analysis of the raw materials used in the manufacture of the
above products.
Your help and efforts are required to protect and keep our environment clean. Therefore
either return this product at the end of life to the manufacturer or ensure WEEE compliant
collection and treatment yourself. Do not dispose of as unsorted municipal waste.
Warranty
Pico Technology warrants this oscilloscope accessory for normal use and operation within
specifications for a period of two years from date of shipment and will repair or replace any
defective product which was not damaged by negligence, misuse, improper installation, accident or
unauthorized repair or modification by the buyer. This warranty is applicable only to defects due to
material or workmanship. Pico Technology disclaims any other implied warranties of merchantability
or fitness for a particular purpose. Pico Technology will not be liable for any indirect, special,
incidental, or consequential damages (including damages for loss of profits, loss of business, loss
of use or data, interruption of business and the like), even if Pico Technology has been advised of the
possibility of such damages arising from any defect or error in this manual or product.
Made in Germany.
Information in this publication supersedes that in all previously published material.
Pico Technology
is a registered trade mark of Pico Technology Ltd.
Copyright © 2020 Pico Technology Ltd. All rights reserved.
