SMS Alert Alarm / Plus
Page 5 of 5
How to operate the microphone to silently listen in
You are able to phone the SMS Alert and listen in for noises within a 20m radius. Phone the SMS Alert and wait
for it to auto answer. It will auto answer automatically after two rings.
Siren
If B is enabled (yellow LED on) and the unit is armed, the siren output relay will trigger for 1 minute and then
reset. E.g. the siren will switch off (time-out) after 1 minute.
General Definitions and advance information
*Advanced settings should only be changed if really needed.
1
To request the
status of the SMS
Alert at any given
time,
SMS
1234 r
or
1234 R
The SMS Alert will respond with, for example, the following:
INPUT ON B- -
- , #000 #87654321
INPUT
means: - Inputs 1 to 8 are enabled or disabled (except input
2)
# 87654321
means: - All inputs are on.
# 00000001
means: - Input 1 is on and the rest are off.
#ABC
means: - All relays are switched on.
#A00
means: - Relay output A is switched on and the rest are off.
B- - -
means: - Reports to one cellphone
2
* Changing the
security code 1234
The default code is 1234 and can be changed through these steps:
1. SMS
1234 04
to the SMS Alert to enable it to change the code.
2. Send
1234 CODE
to the SMS Alert..The SMS Alert will SMS back:
CODE ?
3. You can now SMS your selected 4 digit numeric code, e.g. 5678.
This code is used as a prefix to operate all commands.
3
Panic Input
This input is always on and does not depend on the Key Switch.
4
Key Input
This input enables or disables the 8 inputs. The Key Input is on by default
because of the red loop wire.
E.g: A relay output can be used to arm and disarm the SMS Alert from
another cellphone.
5
Green LED
Indicates when the SMS Alert is sending a SMS. The LED will stay on for 3
seconds.
If the light is flashing, a problem exists
. See troubleshooting.
6
Yellow LED
Indicates when B is active, e.g. the SMS Alert is now enabled. If
B
is the
main user and it is off, then
C
,
D
and
E
won’t work even if it was
programmed.
7
Red LED
Indicates when the
Key input
is enabled. When the red LED is on, all 8
inputs are ready to be triggered.
Input 2 is always enabled.
8
Triggering of inputs
The inputs are triggered negatively by default. To change to
negative
remove
, SMS
1234 03
. The SMS Alert will reset and power up again. This
implies for
Version 7.3 and up.
9
Missed Call function
This is only applicable to input 1 and for user B (first user). The missed call
function can be switched (toggled) on and off by sending:
1234 01
(this is
