PIAGGIO Liberty 50 4T, Manual, Page: 40 / 64

03_18
« A » on the front of the unit as shown in figure 1. Before adjusting the headlamp angle,
make sure the tyres are inflated to the pressure specified on pneumatic section.
03_19
Frontdirectionindicators (03_19)
Use a Phillips screwdriver on the screw « C » shown in the figure. The bulb has a
bayonet fitting, to remove it press gently, and turn it anticlockwise about 30° and then
withdraw it. To refit follow the same steps but in reverse order.
03_20
Rearopticalunit (03_20)
To access the taillight, remove the 2 screws « D » that secure it. To access the turn
indicator bulbs remove screws « E ». The bulbs have a bayonet coupling, to remove
them press gently and twist counterclockwise about 30°. To reassemble the parts
follow the above steps on the opposite order.
N.B.
IF MISTING IS NOTICED ON THE INSIDE OF THE HEADLAMP GLASS, THIS
DOES NOT INDICATE A FAULT AND IS ATTRIBUTABLE TO HUMIDITY AND/OR
TO LOW TEMPERATURES.
THE PHENOMENON SHOULD QUICKLY DISAPPEAR WHEN THE LIGHT IS
SWITCHED ON.
40
3 Maintenance