PIAGGIO Liberty 50 4T, Manual, Page: 39 / 64

03_15
03_16
Frontlightgroup (03_15, 03_16)
To access the bulbs in the headlight assembly, remove the front handlebar fairing as
follows:
1) Disassemble the rear-view mirror following the instructions and figure on section «
Adjusting The Rear-View Mirrors » .
2) Unscrew the 3 handlebar fairing screws, i.e. the front central screw « B » and the
two rear screws « A » .
3) Remove the handlebar fairing to access the headlight and bulbs.
USE A SCREWDRIVER WITH A WORKING END APPROPRIATE TO THE SCREW
SIZE TO AVOID DAMAGING THE PAINTWORK.
Electric characteristic
Headlight bulb
1 high beam/low beam twin-filament bulb
1 position light bulb
03_17
Headlightadjustment (03_17, 03_18)
Set the unladen scooter on level, even ground at a distance of 10 m from a flat wall
or screen that is sufficiently darkened to be able to see the beam. Make sure that the
scooter axis is at right angles to the screen.
Mark the screen with a horizontal line 88 ÷ 90 cm. from the ground.
Start the engine, switch on the headlight dipped beam and position it so that the
boundary between the brightly illuminated area and the surrounding area is no higher
than the line you have drawn. To change the position of the headlamp turn the screw
39
3 Maintenance