PIAGGIO Beverly 300 i.e., Service Station Manual, Page: 117 / 333

- Remove the 5 screws, found on two different lev-
els, as well as the small casing.
Removing the driven pulley shaft bearing
- Remove the clip from the inside of the cover.
- Remove the bearing from the crankcase by
means of:
Specific tooling
020376Y Adaptor handle
020375Y 28 x 30 mm adaptor
020412Y 15-mm guide
Refitting the driven pulley shaft bearing
- Slightly heat the crankcase from the inside so as
not to damage the painted surface.
- Insert the bearing in its seat.
- Refit the Seeger ring.
CAUTION
USE AN APPROPRIATE REST SURFACE TO AVOID DAM-
AGING THE COVER PAINT.
N.B.
ALWAYS REPLACE THE BEARING WITH A NEW ONE
UPON REFITTING.
Specific tooling
020376Y Adaptor handle
020357Y 32x35-mm Adaptor
020412Y 15-mm guide
Baffle roller
Beverly Tourer 300 i.e.
Engine
ENG - 117