background image

ー1ー

PKI-0055

PKI-0055

⑤ O-ring(Red)

 【2 pieces】

④ Hexagon wrench

 【1 piece】

Thank you very much for purchasing PIAA product.  Read this instruction 

manual thoroughly for proper use of the product.  After completing your 

installation, please keep this manual for future reference.

 For customers …………………………・ Please forward this manual to the next owner.

For installation service agents    ……… Be sure to hand over this instruction manual to 

the customer after installation.

marks and         marks

  in this manual indicate important notices for 

  installing this product. Be sure to follow these 

  notices in order to ensure safe and reliable work.

Indicates procedures or situations 
that may cause bodily harm if used 
improperly.

Indicates items that may cause 
damage or abnormality to products 
if used improperly.

Installation Manual for G3 LED Bulbs (Type HB3/HB4/HIR1/HIR2)

Contents

① LED bulb 

(HB3/HB4/HIR1/HIR2 type)【2 pieces】

② Controller【2 pieces】

③ Tie wrap【6 pieces】

(6)Fix the controller (part②) in place on the vehicle side using the tie wraps provided (part ③).

(7)  Check that the LED bulb lights up properly and make sure the light beam is not set too high or 

too low. If the light beam is not properly aligned, make the necessary adjustments.

(5)Connect the vehicle's connector to the connector on the controller (Part ②) and make sure the 

lamp lights up.

notch

controller (Part ②)

vehicle's connector

Viewed from the side

Harness on 
vehicle side

tie wrap (part ③)

controller (part ②)

controller (Part ②)

tie wrap (part ③)

Cut

Cut

Harness on vehicle side

Summary of Contents for G3 LED Bulbs

Page 1: ...that may cause bodily harm if used improperly Indicates items that may cause damage or abnormality to products if used improperly Installation Manual for G3 LED Bulbs Type HB3 HB4 HIR1 HIR2 Contents LED bulb HB3 HB4 HIR1 HIR2 type 2 pieces Controller 2 pieces Tie wrap 6 pieces 6 Fix the controller part in place on the vehicle side using the tie wraps provided part 7 Check that the LED bulb lights ...

Page 2: ...ve corner sensors sonar there is a possibility that these type of sensors may not operate properly Make sure to install the controller approximately 20cm or more away from the sensor Precautions for Use Do not touch the LED bulb directly as it is extremely hot when it is illuminated and also retains considerable heat immediately after turning it off Do not look directly at the lamp for extended per...

Page 3: ...ion If moisture is present let it dry out thoroughly before use Bulb replacement should be done safely on a flat surtace where a wide space is available Before replacement stop the vehicle engine apply the emergency brake place the shift in parking or neutral position and pull out the key Do not yank on the harness when disassembling Doing so may damage the harness leading to overheating and potent...

Page 4: ...mall protrusion is at the top Sideways PKI 0055 PKI 0055 ー4ー The harness is pointing downwards O ring 1 Replacement procedure Procedures for replacing the O rings 1 Before starting the installation work refer to the vehicle s installation manual and verify the place where the bulb will be installed and carry out the installation 2 First verify that the bulb is currently installed on the vehicle Re...

Reviews: