5 Installation
24
Version: 1.2
MP105E
M-232 Linear Actuator
4. Insert the mounting shaft of the actuator into the horizontal hole on the front of
the micropositioning stage until the locating surface of the actuator and the
front of the micropositioning stage touch. The grub screw is then precisely
above the circumferential groove of the mounting shaft.
Figure 9: Introducing the shaft
5. Screw in the grub screw until you feel resistance. The torque must
not
exceed
0.3 Nm.
Fine adjustment: If necessary, correct the position of the locating surface of
the actuator in relation to the top edge of the micropositioning stage while or
before tightening the grub screw so that they are flush with each other.
Figure 10: Fastening the actuator
6. Check that the actuator is correctly fitted on the micropositioning stage:
−
Make sure that the installation result corresponds to the conditions in the
following figure.