PI M-228 Series, User Manual, Page: 26 / 49

5 Installation
22 Version: 2.0.0 MP86E M­­228 / M­­229 Linear Actuators
Figure 7: Clamp connection (schematic)
1 Mechanical mounting
2 Sleeve
3 Mounting nut
4 Mounting shaft with thread
5 Pusher with tip (flat)
We recommend installing the actuator in the mechanical mounting with a clamp connection.
The following instructions refer to this case.
Requirements

You have read and understood the general notes on installation (p. 17).

You have provided your application with a suitable mounting for the mounting shaft of
the actuator.
Tools and accessories

Supplied hook wrench (p. 12)
Installing the M­228 / M­229 in a mechanical mounting
1. Loosen the mounting nut on the mounting shaft of the actuator.
2. Position the actuator in the mounting of your application.
3. If necessary, put a suitable flat washer or a suitable spring washer onto the mounting
shaft.
4. Turn the mounting nut a few times by hand into the thread of the mounting shaft.
5. To clamp the actuator in the mounting, tighten the mounting nut using the supplied
hook wrench until you feel a resistance. The torque may not exceed 15 Nm!
6. Check that the actuator is correctly fitted in the mounting.