User Manual
MP40E, version 1.2.0, valid for M-227.10, M-227.25, M-227.50
CBo, 5/20/2019
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany
Page 13 / 26
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email
Replacing the Standard Flat Tip (Optional)
NOTICE
Damage due to excessive torque on the pusher!
Excessive torque on the pusher (e.g., when the tip is replaced) can damage the M-227.
Do
not
exceed a torque of 1 Nm on the pusher.
Requirements
You have read and understood the safety precautions (p. 7).
The M-227 is
not
connected to the electronics.
Tools and accessories
M-219 tip or P-855.20 piezo actuator (p. 11)
AF 10 open-end wrench
AF 13 open-end wrench (only for P-855.20)
Replacing the standard flat tip (optional)
1.
Unscrew the standard flat tip from the pusher carefully using an AF 10 open-end
wrench. Do
not
exceed a torque of 1 Nm when unscrewing.
2.
Screw the new tip into the pusher:
Only with the M-219 tip:
a)
Screw in the M-219 tip by hand.
b)
If necessary, tighten the connection lightly using an AF 10 open-end wrench.
Do
not
exceed a torque of 1 Nm when tightening.
Only with the P-855.20 piezo actuator:
a)
Screw in the P-855.20 piezo actuator by hand.
b)
If necessary, tighten the locking ring of the P-855.20 lightly using an AF 13 open-end
wrench. Do
not
exceed a torque of 1 Nm when tightening.
Connecting the M-227 to the Electronics
Requirements
You have read and understood the safety precautions (p. 7).
You have read and understood the user manual for the electronics.
The electronics are switched off, i.e.,
not
connected to the power source.
Tools and accessories
C-815.38 motor cable (p. 10)