User Manual
F712T0002, valid for F-712.MA1 and F-712.MA2
Mma, BRo, 12/6/2019
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany
Page 18 / 45
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email
Requirements
You have read and understood the safety instructions (p. 7).
The NanoCube® nanopositioner and the M-122K025 linear stages are
not
connected to
the controller.
You have provided a suitable surface:
−
There are four holes (F-712.MA1) / eight holes (F-712.MA2) to affix the mechanics
with screws M6x25. For the required position and depth of the holes, see
"Dimensions" (p. 39).
−
The flatness of the surface is ≤ 5
µm.
−
For applications with large temperature changes: The surface should have the same
thermal expansion properties as the F-712 mechanics (e.g., surface made of
aluminum).
You have accounted for the space required to route cables without bending and
according to regulations.
For F-712.MA2 in addition:
The position and orientation of the two stacks must be adapted to the required
distance and orientation of the fiber holders within your application.
Standard orientation: The two stacks of the double-sided system face each other, while
the reveiver stack is rotated 180° and the X axes of sender and receiver are collinear;
see also the figure below.
Figure 6: Standard orientation of sender and receiver stacks; bottom view
1
Z-adapter of the XYZ-assembly
2
NanoCube® nanopositioner
3
Drive component of the NanoCube® nanopositioner
