7 Start-Up
48
Version: 2.0.0
MS205Equ
C-863 Mercury Controller
If communication has been successfully established, the
Start up controller
window switches to the
Select connected stages
step.
7.4.2 Establishing Communication via USB
INFORMATION
If the controller is connected via the USB connection and switched on, the USB
interface in the PC software is also shown as a COM port.
Prerequisites
You have read and understood the General Notes on Start-Up (p. 41).
The C-863 is connected to the USB interface of the PC (p. 37).
Prior to switching on the C-863, you have set the DIP switches for the
controller address to the address 1 (p. 42).
The C-863 is switched on (p. 45).
The PC is switched on.
The required software and USB drivers are installed on the PC.
You have read and understood the manual of the used PC software. The
software manuals are found on the product CD.
Establishing communication
1. Start PIMikroMove.
The
Start up controller
window opens with the
Connect controller
step.
−
If the
Start up controller
window does not automatically open, select the
Connections > New...
menu item in the main window.
