phyBOARD-Wega AM335x [PB-00802-xxx]
54
©
PHYTEC Messtechnik GmbH 2014 L-792e_1
3.2
Functional Components on the phyBOARD-Wega SBC
This section describes the functional components of the phyBOARD-Wega. Each subsection
details a particular connector/interface and associated jumpers for configuring that
interface.
3.2.1
Power Supply
Do not change modules or jumper settings while the phyBOARD-Wega is
supplied with power!
3.2.1.1
Power Connectors (X67 and X72)
The phyBOARD-Wega is available with three different power supply connectors. Depending
on your order you will find one of the following connectors on your SBC:
1.
a 2-pole PHOENIX MINI COMBICON base strip 3.5 mm connector (X67) suitable for a
single 5 V supply voltage, or
2.
an USB Micro-AB connector (X72) to connect a standard 5 V USB power supply, or
3.
a 6-pole WAGO male header (X67) to attach the Power Module for phyBOARDs
(PEB-POW-01) which provides connectivity for 12 V – 24 V
The required current load capacity for all power supply solutions depends on the specific
configuration of the phyCORE mounted on the phyBOARD-Wega, the particular interfaces
enabled while executing software, as well as whether an optional expansion board is
connected to the carrier board.
Figure 3:
Power Supply Connectors
PHOENIX MINI COMBICON base strip
WAGO male header 6-pole
