XL5 and XL RF
ENGLISH
68
3. Assemble axle and propulsion wheel with one handrim:
a. Place inner locking shaft coupling
I
on axle
J
.
b. Insert axle
J
through wheel hub.
c. Fasten the outer locking shaft
coupling
K
on axle
J
with a 13mm
wrench while holding the axle
flats with another 13mm wrench.
d. Make sure there is not rotation
between propulsion wheel and
axle.
e. Secure the axle
J
by tightening
locknut
L
with a 13mm wrench.
4. Install propulsion wheel assemblies:
a. Insert the axle of the propulsion
wheel assembly
M
into the axle
retention device
N
while
keeping the lever
O
engaged.
b. Release lever
O
and make sure
propulsion wheel assembly
M
cannot be removed.
c. Repeat these steps for the
opposite side.
5. Install spring loaded shaft on axles:
a. Place spring loaded shaft
P
on
the end of an axle.
b. Compress the spring-loaded
shaft and position the other end
on the opposite axle.
c. Make sure the spring-loaded
shaft is properly installed by
turning the small inner handrim
and checking that movement is
transmitted to the opposite
propulsion wheel.
