Physio Control LIFEPAK 15, Operating Instructions Manual

Page: 213 / 284

Chapter 10 | Maintaining the Equipment
©2007-2015 Physio-Control, Inc. LIFEPAK 15 Monitor/Defibrillator Operating Instructions
213
To return the LIFEPAK 15 monitor/defibrillator to service, perform the following tasks:
•
Complete the tasks listed in the Operator’s Checklist located at the end of this manual. If the
Operator’s Checklist can not be located, a copy is available at www.physio-control.com.
•
Consider having the device serviced by a qualified service technician.
Loading Paper
Check the amount of paper in the printer as part of the daily check according to the Operator’s
Checklist provided in the back of this manual.
Possible Printer Malfunction
Using other manufacturers’ printer paper may cause the
printer to function improperly or damage the print head.
Use only Physio-Control printer paper.
The printer is equipped with an out-of-paper sensor to protect the printer printhead. The sensor
automatically turns off the printer if paper runs out or the printer door is open.
To load paper:
1. Lift the printer door latch to release the door (see Figure, Loading Paper).
2. Pull out the printer door.
3. Remove the empty paper spool, if present.
4. Insert a new paper roll with the graph side facing up. Make sure the end of the paper extends
outward so it is exposed when the printer door is closed.
5. Close the printer door and press down on the latch until the door clicks shut.
Figure 53
Loading Paper