Phottix Juno Li60, Manual

Page: 17 / 44

17
Please note:
- In Ares II Rx (Receiver) Mode there are no wireless TTL
Functions such as HSS or SCS, or wireless power/zoom control.
- Power and zoom levels must be set manually on the Juno
Li60 flash while in Ares II Rx Mode.
- Digital ID is only available in CH5-16, CH1-4 cannot set.
S1 / S2 Rx optical slave Mode
S1 / S2 Rx Optical Slave Mode allows the Juno Li60 to be
triggered in manual mode by other flashes.
Adjusting power and zoom
1. Adjusting Power: Press OK Button to enter power
adjustment area. Use the Selection Dial to change the
power. Press the OK Button to confirm and exit.
2. Adjusting Zoom: Press “Zm” Button to enter zoom
adjustment area. Use the Selection Dial to change the zoom.
Press the OK Button to confirm and exit
6. Other Functions
Auto Save Function
The Juno Li60 Hot Shoe Flash will remember flash settings. Such
as mode, power levels. These will be retained in the flash if it is
turned off and then back on.
Auto Sleep Function
To save battery power the Phottix Juno Li60 Flash is equipped
with Sleep and Auto Off Modes.
1. In Non-Wireless Slave Modes: The flash will go into Auto Sleep
Mode after 10 min. if no Buttons have been pressed or it has not
been fired. The flash LCD will go blank. Pressing the test Button
on the flash will wake up the Phottix Juno Li60.
2. In Wireless Slave Mode, the flash will go to Slave Sleep Mode
after 10 minutes if no Buttons have been pressed or it has not
been fired. Full-pressing the camera shutter Button or pressing