FASTCAM-X1280PCI Series Hardware Manual
- 25 -
2.4.2. Installing internal sync cables
After Master/Slave set up of the grabber boards, install the sync cables between the boards
1) Position of internal sync connectors
Connectors for internal sync signal input/output are located at the position on the board as shown
below. For multi-camera sync operation, connect between these connectors on respective boards
using the attached cables.
BD_IN
BD_OUT
・
BD_IN Connector
Receives internal sync and trigger signals from BD_OUT connector of another board.
・
BD_OUT Connector
Outputs internal sync and trigger signals.
Summary of Contents for FASTCAM-X 1280PCI
