Photron FASTCAM SA7, Hardware Manual

Page: 22 / 87

Chapter. 2 Setup
8
2.2.3. Status Display LEDs on the Rear of the Camera Body
There are a number of LEDs on the rear of the system's camera body. These LEDs indicate the
status of the system. The meaning of each LED is explained here.
Status Display LEDs

POWER (Green)
LED ON: Power On
LED OFF: Power Off

IF LINK/TRANS (Red)
LED ON: The Gigabit Ethernet interface is connected
LED FLASHING: Data is transferring
LED OFF: The Gigabit Ethernet interface is not connected

TRIGGER (Yellow)
LED ON: A trigger signal has been input (illuminates for 0.1 s when the trigger signal is input)
LED OFF: A trigger signal has not been input

IRIG (Green)
LED ON: A IRIG signal has been input
LED OFF: A IRIG signal has not been input

SYNC MODE (Red)
LED ON: In external synchronization mode
LED OFF: In internal synchronization mode

SYNC IN (Yellow)
LED ON: A synchronization signal is being input
LED OFF: A synchronization signal is not being input

REC READY (Yellow)
LED ON: Ready to record
LED FLASHING: ENDLESS recording ("REC" LED also simultaneously flashes)
LED OFF: Not ready to record

REC (Red)
LED FLASHING: Recording
LED OFF: Not ready to record