MS 1002 - 9
MS 1002
If you want to change settings in "Programm 2"
and "Programm 3" then repeat the Steps 1 to 3
by pressing the corresponding button. The tem-
perature setting is changed in 1°C steps.
Positioning "späteres Startens" (=”starting
later”)
At factory setting the time for starting later (spä-
teres Starten) is 0 minutes The delay you want
the machine starting later is expressed in hours
and minutes For example 9:45 means that 9
hours and 45 minutes will pass before the was-
hing machine will start.
If you want to change the time please do the fol-
lowing:
1. Press and hold button "späteres Starten".
2. Change value by pressing b/- in
steps of 5 minutes.
3. Release buttons and press "Stop".
The programmed value is the same for "Pro-
gramm 1", "Programm 2 and "Programm 3".
If “starting later” is active you can see a clock in
the display. If you want to activate starting later
press the button "späters Starten". If you want
to start the machine immediatly after you´ve first
time pressed the button press button a second
time. (There will be no more clock showed in the
display).
Turning into the emergency program
(device
switches into the emergency program after a
blackout itself)
If there is a error or defect part at any time, you
can turn the Ms1002 into a emergency program,
so you can use your washing machine, like the
MS1002 weren´t installed. In this program the
cold water valve is open and the power is
always on.
To activate the emergency program, just press
the buttons "Programm 1", "Programm 2" and
"Programm3" at the same time.
Reset
With that, all parameter will be restored
to the default settings.
1. Switch of MS1002
2. Press button "Start" and "Stop" at the
same time and hold both
3. Switch MS1002 back on again and wait
until the display will appear again
4. Release the buttons
Errorcodes
E-1 = Short-circuit
E-2 = The connection to the temperature sensor
has been cut, for example the plug
isn´t installed properly.
E-3 = Humidity sensor has triggered
E-6 = Emergency program or after a blackout
E-7 = Short-circuit in the magnetic valve(s)
Remedy the error and press the "Start"
button before restarting, to delete the
error-message.
If the water is colder than 5°C the temperature
sensor has to be deactivated, or the error code
“E" will appear. For that switch off the MS1002,
press and hold the "Programm 2" key, and
switch the MS1002 back on. Release the button
not until the temperature is shown in the display.
After 60 seconds the setting is saved. Press,
while a programmis running, the button "Pro-
gramm2" to switch the temperature sensor off.
An "A" will appear in the lower half of the
display, which means that the temperature sen-
sor is switched off. The temperature sensor can
even be activated by doing that steps again.
Only the cold
water valve is opened
Complete display
is flashing
Complete display
is flashing
flashing