8 - MS 1002
MS 1002
7. Initiation MS1002
1.
Turn on MS1002 by using the on/off
switch Now program 1 without prewash is
chosen
2. Press button "mit/ohne Vorwäsche" to switch
pre-wash on or off (A = on, B = off)
.. choose the washing program (Programm 1,
Programm 2, Programm 3)
3. Fill your washing machine like you are used
to do (Put laundry in, fill washing agent in, adjust
your washing machine and switch it on)
4. Press the start button on the MS1002. The
washing machine starts now. The MS 1002 con-
trols now with the standard settings .
After about 26 min. delay at the main washing
programm (without breaks) the hot water valve
close itself and the cold water valve will be ope-
ned at least for 2 hours. Soonest now a 2 hour
remaining time will be showen at the display.
After that the display will show "Aus", what
means that the MS1002 is finished but the
power is still on. The programm for your washing
machine will end earlier so you can at that time
take your clothes out of the washing machine.
Now you can press the "Stop" button and
switch the device out or press the "Stop" button
and continue washing clothes. If you forget to
press "Stop" after the washing machine has
ended its programm before switching the
MS1002 off, at the next start the error code E-6
will appear but you can delete this error by pres-
sing the "Stop" button.
8. Urgent notes for programming MS1002
1. If the display is flashing, you´re at the pro-
gramming mode.
2.
Programmed values will only be saved if at
least one stage of the washing program has
been finished before the device is switched
off.
3. The soaking time arise from setted time of bre-
aks multiplied with the sum of breaks.
Example: 10 min x 4 breaks = 40 min soaking-
time.
Please program not more than 4 breaks.
Positioning of pre-wash temperature
At factory setting a temperature of 5 °C is set in
"Programm 1" and a temperature of 30 °C is set
in "Programm 2" and "Programm 3"
If you want to change the temperature please do
the following:
1. Press and hold button
"mit/ohne Vorwäsche".
2. Press and hold button "Programm 1".
3. Change value by pressing b/-.
4. Release buttons and press "Stop".
The programmed value is the same for "Pro-
gramm 1", "Programm 2 and "Programm 3".
Positioning of main-wash temperature
At factory setting a temerature of 30°C is set in
"Programm 1" a temperature of 40°C is set in
"Programm 2" and a temperature of 60°C is set
in "Programm 3"
If you want to change the temperature please do
the following:
1. Press and hold button "Programm 1".
2. Change value by pressing b/-.
3. Release buttons and press "Stop".
flashing
flashing
temperature