Phonic MM 1805, User Manual

Page: 8 / 40

7
9
. AUX
This rotary fader sends out the channel signal to
AUX
bus. The signal can
be pre-fader so that the aux send will not be affected by the fader, which is
suitable for foldback or monitor; it can be Post-fader, which is suitable for
effects signal that fade up and fade down with the fader. PRE or POST aux
signal is controlled by a slide-switch (10).
10
. AUX PRE/POST SWITCH
The switch allow user to set the AUX send at per-fader or post-fader opera-
tion .
11
. EFX
This rotary fader feeds the channel signal to the built-in digital effect and
main effect mix out as well. The signal is post fader. This is very helpful to
simulataneously adjust the level of the processed and direct signal.
12
. PAN
This control sets the amount of the channel signal feeding the left and right
mix bus, allowing you to locate the source smoothly across the stereo
image. When the control is turned fully right or left, you are able to route
the signal to either left or right output.
13
. Peak LED Indicator
LED lights up when an excessively high signal level is present in the
channel. In general, Input level should be set to the level where the LED
flashes briefly on the loudest peaks only; if it flashes continuously, turn the
input control down slightly. This ensures the best possible signal-to-noise
ratio and dynamic range.
14
. CHANNEL ON/OFF SWITCH
All outputs from the channel except inserts are enabled when the switch is
down, when the On switch is released, the related channel is muted. This
allows levels to be preset before the signal is required. While switching on
the button, the indicated LED would light.
15
. CHANNEL FADER
A long-throw 60mm linear fader determines the proportion of the channel in
the mix and provides a clear visual indication of channel level.