15
Leaving a MultiTalker Network
The MultiTalker Network cannot exist without the presence of your initiating inspiro in the
network. If you decide to end the MultiTalker Network, the entire network will cease and all
of the inspiro and DynaMic transmitters will activate an alarm.
If you are using an inspiro that just joined a network, you can always leave the network by
selecting Stop MultiTalker Network.
Your inspiro will then be set to single teaching mode, but all of the other inspiro
transmitters in the MultiTalker Network will remain in MultiTalker Network mode.
If you are switching off one of the DynaMic, it will be deleted from your participants list.
The MultiTalker Network could continue with all other DynaMic and inspiro transmitters.
Should you unintentionally be outside the distance range of the MultiTalker Network, you
will be alerted by an alarm. You can then choose to either return to the operating range of
a maximum 8m / 25 feet from the initiating inspiro, or to leave the network.
Practical tips
•
The MultiTalker network setting is stored in the inspiro transmitters. If the inspiro and
DynaMic transmitters have been switched off in MultiTalker Network mode, e.g. before
lunch, when decided to then switched back on again after lunch, the MultiTalker
Network mode can be selected by simply pressing a key in the inspiro. In this case,
there is no need to re-initiate the network.
However, start the inspiro first
. All the
DynaMic transmitters will join the network in the pairing window of 8 sec after the
initiator inspiro was switched on.
•
If you have set up a MultiTalker Network with for instance two inspiro transmitters and
then a third person needs to subsequently join the network with inspiro or DynaMic, it is
necessary to set up a new network (to initiate a new MultiTalker Network).
•
inspiro and Dynamic transmitters joining a network automatically use the FM channel of
the initiating inspiro in the MultiTalker Network.
•
If an inspiro reverts to single teaching mode, it automatically applies the FM channel
used previously.
•
If the initiating inspiro alters the FM channel in MultiTalker Network mode for any
reason, the new channel will automatically be sent to the other inspiro and DynaMic
transmitters in the network and then activated.
Summary of Contents for DynaMic
Page 1: ...1 User Guide DynaMic ...
