PAGE # 9
Call 1-877-744-3649 for assistance or visit us at www.phoenixinno.com
USE OF ELECTRICAL ACCESSORIES
1.
If an accessory is used on this appliance that requires an external electrical power source, the accessory when installed must be electrically
grounded in accordance with local codes. In the absence of local codes, use the:
United States: National Electrical Code, ANSI/NFPA 70
Canada: Canadian Electrical Code, CSA C22.1
2.
The accessory should be equipped with a 3 prong (grounding) plug for your protection against shock hazard and should be plugged directly
into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.
3.
Keep any electrical supply cord and the fuel supply hose away from any heated surface.
LIGHTING INSTRUCTIONS
A
Main burner control knobs
B Lid
C Lid
handle
D
Rotisserie burner control knob
E Side
burner
control
knob
F LP
tank
G Lighting
hole
H Cylinder
valve
I Grill
Light
J Match
Stick
1.
Ensure the appliance is assembled in accordance with the manufacturers instructions.
2.
Ensure that the LP gas cylinder or NG supply is properly connected and full (for LP models).
3.
Inspect the hose before each use. If evidence of abrasion, wear, cuts or any other
damage exists, replace the hose before using the appliance.
Use only replacement parts from Phoenix Innovations Corp.
4.
Ensure that there are no gas leaks. See “Leak Test” section of this manual.
5.
Ensure that the venturi tubes/burners are properly aligned on the burner control valve orifices.
(See Fig. 1)
6.
Ensure that the main, side and rotisserie ignitor wires are properly connected.
7.
Read and understand all instructions as they pertain to this appliance before lighting.
8.
Open the lid and make sure the burner control knobs are in the “OFF” position.
9.
Slowly open LP gas cylinder service valve or NG suppy valve.
10.
MAIN AND SIDE BURNER(S):
Push and turn desired burner control knob(s) to the “HIGH” position.
The ignitor will light the burner.
ROTISSERIE BURNER:
Push in, turn and
hold
control knob to “HIGH” position for approximately 10 sec. to activate the saftey valve.
Once burner is lit, position the control knob to desired setting and release control knob. If ignition does not occur within 5 sec.,
or burner goes out, turn burner control knob(s) “OFF”, wait 5 min. and repeat lighting procedure.
11.
If ignition does not occur within 5 sec., turn burner control knob(s) “OFF”, wait 5 minutes and repeat
lighting procedure. If any burner will not light, refer to the “Trouble Shooting” section of this manual.
If the problem can not be resolved, contact our customer service department at
1-877-744-3649
, www.phoenixinno.com or
a licensed gas technician before using the appliance.
12.
Do not operate the main and rotisserie burners at the same time.
13.
When on “HIGH” position, the main burners should provide a 1” (2.5 cm) flame.
(See Fig. 2-1)
For Models:
PH603SB
PH603SBN
1” (2.5 cm) flame
Fig. 2-1
Tube Burner
Valve orifice
1/4”
Fig. 1
Tube Burner
Valve orifice
✓
✓
✘
✓
