Installation
11
Phoenix PC-1280 USB Digital Camera User’s Guide
Revision 1.1
2.2.2
Distribution Software Installation
The following are the steps to install the Phoenix PC-1280 Distri-
bution Software on the system:
Insert the "Phoenix PC-1280 Distribution Software” CD
into a drive, e.g. X
Browse into the directory X:\Dist\, then run “Setup.exe”
The installation software will show an “Welcome Infor-
mation” panel, click the “Next” button on it
On next page, read the License Agreement and select Yes
or No button
On the “Installation Information” page, a list of files to be
installed will be shown. Click the “Next” button
On the “Choose Destination Location” page, either select
the default folder ("C:\PC-1280\") or create a different di-
rectory, then click the “Next” button
Next is the “Select Setup Type to Install” page. The “Typ-
ical” is recommended
On the “Select Program Folder” page, the user can choose
where the application is located on the Windows Start -
All Programs. The default Folder is “MuTech”. Click the
“Next” button
Now the installation software is ready. On the “Start
Copying Files” page, review the settings. If satisfied,
click the “Next” button to start the installation
Depending on the system, there might be a warning mes-
sage asking if the device driver file (a Read Only File) can
be copied over. If this message pops up, answer “Yes”
and continue
Once the installation is done, the “InstallShield Wizard
Complete” page shows. On this page select the Reboot ra-
dio button, remove the Distribution Software CD, then
click “Finish” to complete the process
At this point, clicking the PhoenixView program icon starts the
PhoenixView - DEMO & Utility Software.