![background image](http://html.mh-extra.com/html/phoenix/humiport-05/humiport-05_installation-operation-and-service-instructions_1551252002.webp)
2
www.UsePhoenix.com • [email protected]
Toll-Free 1-800-533-7533
1 Appropriate Use
The measuring device must only be operated within the
products specifications.
The measuring device must only be used under the
conditions and for the purposes for which it was designed.
Modification to this device will void the warranty and
may compromise the accuracy and safe operation of this
device.
2 Display
3 Operation
The Humiport 05 can be adjusted using the three-way
“Thumb Wheel” on the left hand side of the device.
Up and down movement of the wheel is used to navigate
through different menu items on the screen. Items that
flash intermittently on the screen are items that can be
adjusted. Pressing the wheel inward will act as a “click” or
selection of the highlighted item.
When the unit is first turned on, moving the wheel up or
down will select the upper or lower menus on the screen.
3.1 Three Positions of the Thumb Wheel
s
Turn up
t
Turn down
Press in the middle position
To switch on:
(press briefly)
To switch off:
press for
approximately 2 seconds
(No menu activated)
Upper menu:
s
(press briefly),
select with
s
, confirm with .
Lower menu:
t
(press briefly),
select with
t
, confirm with .
Table of Contents
Introduction
................................................................1
1. Appropriate Use ....................................................2
2. Display .................................................................2
3. Operation .............................................................2
3.1 Three Positions of the Thumb Wheel .................2
4. Upper Menu ..........................................................3
5. Lower Menu ..........................................................3
5.1 Single-Point Calibrations of ..............................3
Temperature and RH
6. Measuring the Humidity Ratio.................................3
7. Replacing the Battery ............................................3
8. Maintenance and Adjustment .................................3
9. Specifications .......................................................4
10. Warranty/Sensor Repair ........................................5
Serial No. ___________________________
Purchase Date ______/______/_____
Dealer’s Name ___________________________________
Read the operation and maintenance instructions carefully
before using this the Humiport 05.
Do not measure near live electrical components.
Avoid using in temperature conditions outside of that
recommended (overheating can lead to their destruction)
Calibration should only be adjusted when used with a
recommended calibration source or known standard.
Allow approximately 2 minutes for stabilization when taking
measurements in dramatically different environments.
IMPORTANT WARRANTY INFORMATION BELOW:
The plastic protection cap must be placed on the sensing
head whenever the meter is not in use. Without this
protection the sensing elements can be mechanically
damaged or chemically contaminated. Meter failures due
to damage or contamination of the sensing elements are
not covered under warranty.
Place the meter in the supplied soft case to further protect
from physical damage and contamination
Upper menu
Hold MAX MIN AVG
888.8
% WT CM m/s °F °C
Temperature display (Unit 1)
Relative humidity display (Unit 2)
Lower menu
888.8
g/m °C °F dp % rH
Unit 12 Cal 12
g/kg gr/lb Alt. [ft]