Step 1
To assemble the back piece:
Lay the back of the carrier flat on a hard surface. Position the back piece so the
bottom is closest to you. Remove the screws from two 14” perches and mount the
two perches to the back piece. Tighten the screws.
Using the hex nut driver and a Philips screw driver, install six clips onto the back
piece. The edge of the clips should be in line with the side edge of the back piece
(Fig 1-1).
Fig. 1-1
Step 2
To assemble the top, bottom, and side pieces:
While not necessary, it may be helpful to have a second person assist in holding
the pieces during this step.
Attach the top and bottom pieces by gently pressing the pegs into the plugs on the
back piece.
Attach the right piece onto the back by gently pressing the pegs into the plugs
(please note the orientation of the logo). Remove the screws from last 14” perch
and mount the perch onto the right-side piece (please note, the perch can be
mounted onto any side hole, this is personal preference). Attach the left-side piece
and screw the perch into the left-side piece. Make sure that all the pegs are
secured into their plugs.