Phoenix 2700 DHP
July 2018
14
•
Recommended settings below are for High temperature (210 F activation)
1.5 and 3 mil film and Low temperature (185 F activation) 5.0 and 10
mil film:
Dial Settings
Film Thickness
Temperature Speed
Approx. Temp display
1.5 mil
7
3
260° F
3.0 mil
7
2
260° F
5.0 mil with Fans ON
6
1.5
234° F
10 mil with Fans ON
6
1
234° F
3.
Pouch board mounting
•
Turn heater switch on rear panel to SINGLE position to turn off bottom heater.
(Allow 20-25 minutes for bottom roller to cool down)
•
Rotate roller gap adjustment handle to position matching board thickness.
•
Turn temperature dial clockwise to desired temperature setting.
•
Turn speed dial clockwise to desired speed setting.
•
Recommended settings for pouch boards is Temperature setting 10 and
Speed setting 1.5.
NOTE:
•
Recommended settings are starting points only and should be adjusted
according to quality of output achieved.
•
Excess heat may damage the printed image or cause waves. Insufficient
heat may result in delamination.
•
Thinner stocks can be run faster, and thicker stocks or heavy ink coverage
should be run slower.
•
Some stocks and ink-sets cannot be effectively laminated with thermal films.
Compatibility testing is recommended before laminating long runs.
WARNING
:
Ensure the
safety shield is in place before operating the
Laminator. Operating without the safety shield can cause
serious injury.
