Phoenix 2700 DHP
July 2018
11
12. Feed Table
1.
Rotate Safety Shield to full upright position
2.
Insert Feed table onto back two positioning pins on both side frames
3.
Retract Feed table safety latch located under right side of table
4.
Lower Feed table onto the front side support pins on both side frames
5.
Slide Feed Table safety latch to the right and locked position to
engage the safety interlock switch
6.
To remove Feed Table, retract safety latch, lift front edge, then back
edge away from support pins, then lift away from machine
Note: The laminator will operate only when the Safety Shield and Feed Table are
in the fully locked position. Both the interlocking switches must be activated
for power to be supplied to the motor
Feed Table
Safety Latch
