Mounting and installation
7966_en_04
PHOENIX CONTACT
2-1
2
Mounting and installation
2.1
Mounting and removing the FL NAT SMN 8TX(-M)
Mount the FL NAT SMN 8TX(-M) on a clean DIN rail according to DIN EN 50022 (e.g.,
NS 35... from Phoenix Contact). To avoid contact resistance, only use clean, corrosion-free
DIN rails. End clamps (E/NS 35N, Order No. 0800886) can be mounted to the right and left
of the device to stop the modules from slipping on the DIN rail.
Mounting:
1
Place the module onto the DIN rail from above (A). The upper holding keyway of the
module must be hooked onto the top edge of the DIN rail. Push the module from the
front towards the mounting surface (B).
Figure 2-1
Snapping the FL NAT SMN 8TX(-M) onto the DIN rail
2
Once the module has been snapped on properly, check that it is fixed securely on the
DIN rail. Check whether the positive latch is facing upwards, i.e., snapped on correctly.
A1
A2
A
