Phoenix Contact 1136419, User Manual, Page: 119 / 130

Appendix for document lists
110146_en_00 PHOENIX CONTACT
119 / 128
B Appendix for document lists
B 1 List of figures
Section 3
Figure 3 - 1: Redundant control system with two RFC 4072R controllers ............... 12
Figure 3 - 2: Marking a variable as redundant in PLCnext Engineer ....................... 13
Figure 3 - 3: Ideal typical system behavior .............................................................. 14
Section 4
Figure 4 - 2: Connection and operating elements of the controller including
fan module ..........................................................................................24
Figure 4 - 3: Information on the label of the RFC 4072R ......................................... 25
Figure 4 - 4: Diagnostic and status indicators ......................................................... 26
Figure 4 - 5: RFC 4072R with fan module ............................................................... 27
Figure 4 - 6: Home menu ........................................................................................ 30
Figure 4 - 7: “CONFIG DETAILS” menu .................................................................. 31
Figure 4 - 8: “CONFIG DETAILS” menu, “INFORMATION” submenu ..................... 32
Figure 4 - 9: “CONFIG DETAILS” menu, “LAN SETTINGS” submenu .................... 33
Figure 4 - 10: “EDIT LANX” submenu (in the example: “EDIT LAN1”) ....................... 34
Figure 4 - 11: Menu for entering the digits ................................................................ 34
Figure 4 - 12: Messages “LAN Setting changed” and “Restart: for new LAN
settings” .............................................................................................. 35
Figure 4 - 13: “EDIT LANX” submenu, message “Nothing changed” ........................ 35
Figure 4 - 14: “CONFIG DETAILS” menu, “MAINTENANCE” submenu .................... 36
Figure 4 - 15: “CONFIG DETAILS” menu, “MAINTENANCE” submenu,
“PLC REBOOT” submenu ................................................................... 37
Figure 4 - 16: Message “Rebooting controller...” ....................................................... 37
Figure 4 - 17: “PLC REBOOT” submenu, message “Nothing changed” .................... 38
Figure 4 - 18: “CONFIG DETAILS” menu, “MAINTENANCE” submenu,
“FACTORY RESET” submenu ............................................................ 39
Figure 4 - 19: “FACTORY RESET” submenu, message “Reset to default!
Are you sure?” .................................................................................... 39
Figure 4 - 20: “MAINTENANCE” submenu, message “Nothing changed” .................40
Figure 4 - 21: “CONFIG DETAILS” menu, “MAINTENANCE” submenu,
“FAN CONTROL DETAILS” submenu ................................................ 41
Figure 4 - 22: “CONFIG DETAILS” menu, “MAINTENANCE” submenu, “FAN
CONTROL DETAILS” submenu, “FAN CALIBRATION” submenu ...... 42