Philips VARILITE VLX3, Service Manual

Page: 31 / 130

T
ROUBLESHOOTING
: E
RROR
M
ESSAGES
0 2 . 9 7 0 3 . 0 0 1 0 0 13
2
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s), one at a time until the end of the list is
reached. To review the error messages again, it will be necessary to access them using the Status
function. (Refer to
“Troubleshooting Guide” on page 14 for a list of possible causes and remedies
associated with the error messages.)
To access error messages:
Step 1. Press [ESC] to access the main menu screen.
Step 2. Press [Up] / [Down] arrows until
Fixture
appears. Press [Enter].
Step 3. Press [Up]/ [Down] arrows to access
Status
. Press [Enter]. (Display will now scroll
through any error messages or display OK if no errors.)
WARNING: As with any repairs or maintenance to VARI
❋
LITE luminaires, service should only be
performed by a trained and qualified service technician or at an Authorized VARI
❋
LITE Service
Center.
Table 2-1: Error Messages
Display Message...
OK No errors found
No Sensor on Tilt Tilt sensor not found
Encoder Error on Tilt Tilt encoder not found
No Sensor on Zoom Zoom sensor not found
Encoder Error on Pan Pan encoder not found
No LED Com Board
Number X
No communication between LED driver board (X = driver
board number 1, 2 or 3) and MCB
No LED Upload Board
Number X
No software upload to LED driver board (X = driver board
number 1, 2 or 3)
LED Error Board
Number X
Problem exists between LED and LED driver board (X =
driver board number 1, 2 or 3)