Mechanical Instructions
EN 15
SDI PDP 2K6
4.
4.1.5
Exchange of LBE and LBF board - 42” HD w1
1.
Remove the screws in order of 1-3-2 from the heatsink and
remove the heatsink (“Photos 1 & 3”).
2.
Remove the TPC, FFC, and power cable from the
connectors.
3.
Remove all the screws from the defective board.
4.
Remove the defective board.
5.
Place the new board and then screw tightly.
6.
Clean the connectors.
7.
Re-connect the TCP, FFC, and power cable to the
connectors.
8.
Re-assemble the TCP heat sink. Use the screw mounting
order 2-1-3.
Caution:
If you screw too tight, it is possible to damage the
Driver IC of the TCP.
Figure 4-12 Photo 1 - Heatsink 42” HD w1
Figure 4-13 Photo 2 - Exchange of LBE, LBF board 42” HD w1
Figure 4-14 Photo 3 - Heat sink removal
1
3
2
G_16380_027.eps
160606
G_16380_024.eps
160606
G_16380_022.eps
160606
