6
Instruction Manual
Swivel Stand
STAND ANCHORING PROCEDURES
NOTE: Due to the wide variety of anchoring options, hard-
ware is not provided.
Anchor stand follows:
1.
Select a suitable location for anchoring, allowing for room
for swivel and access for cabling.
2.
Using the template provided, drill anchoring holes for the
four 1/4-20 X 1/2” tapped holes (see Figure 7).
3.
If routing cables through mounting surface, Use the tem-
plate provided and drill the cable access hole in the
mounting surface.
CABLE MANAGEMENT
Install cables as follows:
1.
Attach cabling to flat panel display.
2.
Route cables in one of three ways:
a.
down the back of the display (open),
b.
through the center post of the stand and out the bot-
tom of the stand in the back,
c.
through the center post of the stand and through a
hole in the mounting surface.
Figure 7. Anchoring Hole Locations
1/4-20 X 1/2” Tapped holes
