EN 12
EasyLink controls
If you connect your TV to HDMI-CEC
enabled devices, such as a Blu-ray player or
home theatre, you can control them at the
same time with one remote control. Simply
switch on EasyLink after connection.
Read more about Easylink in
Connect your
TV > Set up Easylink devices > Control
devices
(Page 47).
On-screen remote control
You can also control connected HDMI-CEC
enabled devices through other buttons that
are available through the on-screen remote
control. Make sure that Easylink is switched
on after connection. Read more about
Easylink in
Connect your TV > Set up
Easylink devices > Control devices
(Page
47).
To access the on-screen remote control
1. While you watch a connected device,
press
OPTIONS
.
2. Select
[Show remote control]
, then press
OK
.
3. Select an on-screen button, then press
OK
.
Watch TV
Switch TV on or off
Switch the TV on
Connect the TV to the mains outlet
and switch on the main power.
If the TV is not switched on, the
standby LED remains off. Press on
the TV.
If the standby LED is lit, press on the
remote control.
Note:
There is a short delay before the TV
responds.
Tip:
If you cannot find your remote control
and want to switch on the TV from standby,
press any button on the TV.
Switch TV to standby
Press on the remote control.
The standby LED on the TV switches to red.
Switch off the TV
Press on the TV.
The standby LED switches to off.
Note:
Though your TV consumes very little
energy when it is in standby or switched off,
it does use some energy. If you are not going
to use the TV for an extended period of
time, disconnect the TV from the mains plug.
Automatic switch off
You can save energy with this TV's energy
efficiency settings, which are enabled by
default. If there is no user interaction (such
as pressing a remote control button or a
control on the TV) for four hours, the TV
will automatically switch to standby.
To disable automatic switch off
1. While you watch TV, press the
Green
button
on the remote control.
2. Select
[Auto switch off]
, then press
OK
.
3. Select
[Off]
, then press
OK
.
