-
For contouring, hold the trimming
head perpendicular to the skin and
move the trimming head upwards or
downwards with gentle pressure (Fig.
5).
5 Turn off and clean the product after each
use (see 'Cleaning').
Trimming with guard
Note: When you trim for the first time,
start at a length setting that is longer
than what you are used to, to familiarize
yourself with the product.
Use the beard guard to trim your beard,
stubble and mustache in your preferred
style.
Turn the zoom wheel to choose from length
settings ranging from 5.4
mm (7/32 in.) to
10
mm (25/64 in.) (Fig. 7). The length settings
are mentioned above the zoom wheel.
1 Make sure the product is turned off.
2 To attach the guard, slide the front part
of the guard onto the teeth of the cutting
unit. Then push down the center of the
guard with your fingers or the palm of
your hand ('click') (Fig. 6).
3 Turn the zoom wheel to select the
desired length setting.
4 Turn on the product.
5 To trim most effectively, move the
product against the hair growth direction.
Make sure that the surface of the guard
always stays in contact with the skin (Fig.
8).
Since all hairs do not grow in the same
direction, you may want to try different
trimming directions (i.e. upwards,
downwards, or across). Practice is best
for optimum results.
6 Regularly remove cut hair from the guard.
If a lot of hair has accumulated in the
guard, remove it from the product and
blow and/or shake out the hairs. The
selected hair length setting does not
change when the guard is removed.
7 Turn off and clean the product after each
use (see 'Cleaning').
- Use this product for its intended
household use as described in this
manual.
- For hygienic reasons, the product should
only be used by one person.
- Note: This appliance can be used without
cord or when it is connected to the wall
socket.
Cleaning
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as petrol
or acetone to clean the appliance.
Clean the product after each use (see
'Cleaning').
1 Turn off the product and disconnect it
from the power outlet.
2 Wipe the housing of the product with a
dry cloth.
3 Clean the trimming head under the tap
(Fig. 9).
4 Pull the back part of the guard off the
product and then slide it off the cutting
unit (Fig. 10).
5 Clean the guard with the cleaning brush
(Fig. 11) and/or rinse it under the tap (Fig.
12).
6 Clean the cutting unit with the cleaning
brush and/or rinse it under the tap (Fig.
14).
7 Carefully shake off excess water and let
all parts air dry completely.
Never dry the trimmer teeth with a
towel or tissue, as this may damage the
trimmer teeth.
Every 3 months: cleaning trimming head
connector
1 Turn off the product and disconnect it
from the power outlet.
2 Pull the cutting unit off the product (Fig.
13).
3 Clean the inside of the trimming head
with the cleaning brush (Fig. 15).
4 Clean the trimming head connector with
the cleaning brush (Fig. 16).
5 Press the trimming head back on the
product. Make sure the projection on the
back of the trimming head fits exactly
onto the notch in the hair chamber (Fig.
17).
