9
EN
1
Press
MENU/OK
.
2
Select
[Answ. Machine]
>
[Remote
access]
>
[Change PIN]
, then press
MENU/OK
to confirm.
3
Enter the old PIN/passcode, then press
MENU/OK
to confirm.
4
Enter the new PIN/passcode, then press
MENU/OK
to confirm.
5
Enter the new PIN/passcode again, then
press
MENU/OK
to confirm.
»
The setting is saved.
Charge the handset
Charge your handset by docking it in either
direction. When the handset is placed correctly
on the base station, you hear a docking tone
(see 'Set the docking tone' on page
21). The
LED at the back of the handset flashes once.
»
The handset starts charging.
Note
•
Charge the batteries for 8 hours before first use.
•
If the handset becomes warm when the batteries are
being charged, it is normal.
•
Over time, capacity of batteries decreases. This is a
normal battery behavior.
Your phone is now ready to use.
Check the battery level
The battery icon displays the current battery
level.
When the handset is off the
base station, the bars indicate the
battery level (full, medium and
low).
The empty battery icon flashes.
The battery is low and needs
recharging.
If you are on the phone, you hear warning
tones when the batteries are almost empty.
The handset turns off when the batteries are
completely empty.
What is standby mode?
Your phone is in standby mode when it is idle.
The standby screen displays the handset name,
handset number, date and time.
Check the signal strength
The number of bars indicates
the connection status between
the handset and base station. The
more bars are shown, the better
the connection is.
•
Make sure the handset is connected to the
base station before you make or receive
calls and carry out the phone functions
and features.
•
If you hear warning tones when you are
on the phone, the handset is almost out
of battery or the handset is out of range.
Charge the battery or move the handset
nearer to the base station.
