Philips IS 5022 Mark II, Instruction Manual

Page: 23 / 42

OPERATION
SETTING TO
WORK
It is important to adhere to the following sequence:
1. Connect the input(s) and output(s) .See Chapter 4.
2.
Make
sure
that the slider switches
B3/B5
on the rear panel
are in the
required position.
3.
Turn the
gain control (potmeters) anti-clockwise to the Unity Gain posi ‑
tion
to avoid excessive volume when the analog input signal is applied.
4.
Switch the unit
on
(POWER
switch).
5. Select the required output sample rate. Default is 48 kHz, if 44.1 kHz is
required press the 44.1 button on the front panel.
6.
Select input
(INPUT switch)
The Sound Enhancer is
now ready for
operation.
te Sound Enhancer
will
not
opele,
Changingof the output
sample
rate during
operation
will
n o t harm the
Sound
Enhancer, however
unwanted
noise or in
some
situations mal ‑
function of
the control
electronics may
occur.
In
case
of a
software
“hang-
u p ”
switch the
unit
o f f
andon
again
to reset.
2 AuDIO EFFECTS
Once the input(s)
and
output(s) have
been connected
f o r the required
function
(see
Chapter
4), any
required effects
can
be activated.
Note: In order to obtain the optimal setting, the Sound Enhancer should
be installed so that the various effects can be heard by means of head ‑
phones or speakers .
The SELECT buttons (+
and
-) sequentially select the following audio
effects:
scratch (suppression)
noise filter
stereo enhancement
compression/expansion
bass
treble
spatial
fade time
(Quantization
Noise Imaging refer section
5.3.)