iColor Flex LMX gen2 Product Guide
19
Mounting Marquee Lenses and Glare Shields to Accessory Mounting Track
1. Clip a lens or glare shield holder to each node.
2. Do one of the following:
• Screw a marquee lens onto the lens holder. Hand tighten to approximately 1.1 to
1.7 Nm (10 to 15 in-lbs).
• Align the tabs on the glare shield with the slots in the glare shield holder, and
snap the glare shield onto the glare shield holder.
3. Cut the Accessory Mounting Track to the desired length with a saw or snips.
Using flathead screws suitable for the mounting surface, drive screws through the
plastic track into the attaching surface. Recommended maximum spacing between
screws is 406 mm (16 in).
4. Snap the assembled iColor Flex LMX gen2 nodes into the mounting track.
5. If using strands with standard 4-in or 12-in on-center spacing, you can snap
optional Accessory Spacers into the track to hide mounting hardware and wires.
Make Power and Data Connections
iColor Flex LMX gen2 strands are designed to work with 24 VDC power/data supplies
from Philips Color Kinetics. Power/data supplies send power and data to iColor Flex
LMX gen2 strands over a leader cable.
PDS-60ca 24V is an IP66-rated power/data supply, suitable for use in damp and wet
locations. Although sPDS-480ca 24V and sPDS-60ca 24V are rated for use in dry
locations only, you can install them in watertight enclosures for outdoor applications.
Make sure the power is OFF before connecting iColor Flex LMX gen2 strands.
Connecting iColor Flex LMX gen2 Leader Cables
Connect a leader cable to the three-pin connector on the end of each iColor Flex
LMX gen2 strand by turning the strand’s grommet clockwise. In wet or damp
environments, tighten the grommet on the male connector sufficiently to ensure a
watertight seal.
PDS-60ca 24V
1
sPDS-60ca 24V
1
sPDS-480ca 24V
8
CM-150 CA 24V
1
Maximum strands per power/data supply
78 mm
(3.06 in)
25 mm
(0.98 in)
16 mm
(0.63 in)
94 mm
(3.69 in)
28 mm
(1.1 in)
6 mm
(0.25 in)
Leader Cable connector dimensions
