Philips HD 5665, Operating Instructions Manual

Page: 6 / 30

Push firmly to ensure that it fits well at the top
(fig. 27).
• Wash the glass jug, filter, filter holder and grid
in hot soapy water. Rinse with hot water.
• Regularly clean the water outlet opening,
removing any stuck grains of coffee.
Descaling
Descale your Espresso Quattro regularly.
With normal household use the following rule
applies:
• If you use soft water (hardness up to 18 °DH /
22.5 °Clarke) - two or three times a year
• If you use hard water (hardness over 18 °DH/
22.5 °Clarke) - four or five times a year.
Your water supply company can inform you
about the hardness of your water.
- Operate the appliance twice as indicated in
section "Making Espresso". However, now use
ordinary vinegar (two Espresso cups) to fill
the water tank and do not fill the filter with
ground coffee.
- To remove any scale setting from the inside of
the steam pipe, let the appliance produce
vinegar steam for some time.
- To remove all remainders of vinegar and scale,
operate the appliance twice with fresh cold
water in the same manner.
Then clean all removable items.
6
Connections - Applicable to U.K. only
IMPORTANT
WARNING - THIS APPLIANCE MUST BE
EARTHED
The wires in the mains lead are coloured in
accordance with the following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN AND
YELLOW must be connected to the terminal
which is marked with the letter "E" or by the
earth symbol
E
or coloured GREEN or
GREEN AND YELLOW.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter "L" or coloured RED.
The wire which is coloured BLUE must be
connected to the terminal which is marked
with a letter "N" or coloured BLACK.
Note: If the terminals of the plug are unmarked
or if you are in any doubt consult a qualified
electrician.
If a (BS 1363) 13 amp. plug is used this must
be fitted with a 13 amp. fuse.