Philips FM92E, Manual

Page: 10 / 86

•
You may like to spray and wipe the front panel with "Mr Sheen" or similar, or "Armour-all" or similar, or
even apply a light coat of clear (matt) varnish (ensure it is safe for plastics!).
•
Ensure you now have, nice and clean:
o
two "channel" buttons
o
three blue buttons
o
two knobs
o
the back panel
o
the front panel
o
and all the screws and hardware you started with. :)
Reassembly
•
Replace the channel change buttons (arrows pointing out) on the front circuit board switches. They
should snap lightly into place.
•
Replace the three blue buttons on their switches.
•
Ensure the three LEDs are still vertical from the circuit board.
•
Re-mount the speaker.
•
Replace the circuit boards into the front panel, ensuring that:
o
the three LEDs and five buttons fit properly into their respective holes
o
the white bracket between the circuit boards is correctly positioned (for the mounting screws to
locate correctly)
o
the hard-wired microphone cable (if fitted) is correctly positioned.
o
the speaker wires are not caught up
•
Replace the screws holding the circuit boards.
•
Replace the "Ext Spk" switch (if fitted).
•
Replace the knobs (they are different!)
•
Replace the rear panel and screws.
Ensure you have no bits left over.
The Microphone
•
Undo the four screws at the back.
•
Separate the back from the microphone
•
blow or brush out any dust
•
spray the PTT contacts with WD-40 or similar, wipe off any excess
•
Reassemble and wipe with "Mr Sheen" or similar.
Finished!
Philips FM92E Conversion to 6 Meters: Version 3.9 Page
10