FC8209/01
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
- First remove the dust bag.
- Remove the dustcover using a screwdriver (see picture).
- When the dustcover has been removed, the 5 screws
A
that
need to be unscrewed to disassemble the upper housing, are
accessible.
A
A
A
A
A
- After removing screw
B
, lift the motor cap (item 14) out of
the lower housing to be able to take out the cord winder
unit.
B
- To disassemble the cord winder, use TORX screwdriver
no. T10, which is one of a set consisting of T20; T15; T10;
T9; T8; T7 and T6 (code number 4822 395 50145).
- During re-assembling, take care the wires are positioned in
the guides correctly.
REPAIR INSTRUCTION
- The spare parts have been standardized as much as possible.
- Depending on the original cord, the spare cord must be
shortened to the length of the original cord.
- The cord winder spring must be tensioned to the maximum
level and then be rewound approx. 1.5 turn
- If the reel half spring unit is replaced, shaft
D
must be
lubricated with silicone grease. Do not apply any silicone
grease to or spill any grease on terminals (item 27) or
conductors (item 26).
- When the vacuum cleaner is used to suck up fine dust, the
pores of the dustbag may become clogged, causing the
passage of air through the dustbag to become obstructed.
As a result, the dustbag-full indicator will indicate that the
dustbag needs to be replaced, even though the dustbag is
not full at all.
ELECTRICAL DIAGRAM
M
MAIN
SWITCH
CORD WINDER
C
2-6
