Philips EasyKey 7100DS, User Manual

Page: 5 / 14

6 7
Step 3
｜
Latch Bolt Reversing
Latch bolt
1. Push the latch bolt directional screw to the
top.
2. Press the latch bolt and rotate it to 180°, then
pull out the latch bolt.
3. Push the latch bolt directional screw to the
bottom.
4. Change the direction of the directional screw
according to the inside and outside opening
requirements.
(The directional screw must be installed on the
inside of the door, that is, which side is equipped
with directional screws, which side must be the
inner body)
1
2
Installation Step
Tighten the four fixing screws on
the mortise.
According to the thickness of the door, to
appropriately cut the mechanical key paddle,
and choose the square shaft and the connecting
screw with proper length to fix the screw.
Attach the connecting bolts and
the mechanical key paddles to the
outer body, and place the pressure
spring and the square shaft in the
handle hole.
3
4
Fasten the mounting plate to the
inside door and tighten the two
fixing screws.
5
6
Change the direction of latch bolt to adapt to the direction of door opening
from inside and outside. The inclined surface of the latch bolt opens toward the
outside door is Inside-open, and the inclined surface of the latch bolt opens
towards the inside is out-open.
Latch bolt slide switch
Directional screw
1.Use proper installation kit according to the door thickness.
2.The default installation kit is applicable to doors of 60-90mm thickness. If the thickness of your
door is not within this range, please contact us.
The following installation steps apply to right-open doors. For left-open
doors,please read [Pre-installation instructions] carefully and make needed
adjustment.
Use the drilling template to drill
the needed holes on the door and
mount the mortise into the door.
Hook the upper and bottom poles
when the mortise is inserted (this
step is not equired when installing
on the wooden door)
Pass the cable through the wire hole
above the door. The mechanical key
pad on the outer body and the square
shaft are inserted into the two rotary
holes on themortise, so that the outer
body is close to the outside door.
Attention
Attention