specifications
4
DUS804C-UP Installation Manual Rev C.docx
Warranty policy
Dynalite warrant to the original purchaser for a period of twenty four (24) months from the date of shipment ex-factory of the
equipment that should the equipment prove defective by reason of improper workmanship or material, Dynalite will repair or replace
the same without charge provided the equipment has not been improperly installed, operated, repaired, damaged or abused. The
warranty granted herein is limited to repair or replacement only. Dynalite has the right to substitute any warranty item not on the
current price/equipment list. As far as the law permits, Dynalite shall not be liable for any loss or damage caused to propert y or
persons arising from any cause whatsoever. This warranty is subject to the return of the equipment to Dynalite, or the Dynalite
authorised distributor who supplied the equipment (the „Supplier‟), by prepaid freight within the twenty four (24) months warranty
period. Where Dynalite, or the Supplier, agree to a site visit during the warranty period and it is found to be an operational problem,
and not subject to warranty in that event, then a field service call out charge will apply. Contact Dynalite or the Supplier for details.
DUS804C-UP Installation Manual Rev C.doc. Specifications and design subject to change without notice. Philips Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921). All rights reserved. Dynalite,
Dimtek, DyNet and DLight and associated logos are the registered trademarks of Dynalite Intelligent Light Pty Ltd. Not to be reproduced without permission.
E-Mail:
Web:
philips.com/dynalite
DUS804C-UP:
PIR:
Maximum detection range: 5.0m
Detection area 7.4m x 5.6m ellipse (at a height
of 2.4m
Detection speed: 1.0m/s
Detection object: 700mm x 250mm
Detection zones: 64
LED activation indicator
Sensor: Quad element pyro-electric
R.F.I Immunity:>15V/m @ 10
– 1000MHz
Ultrasonic:
Normal motion detection area:
8m x 16m (128m
2
coverage)
Transducer pairs 2
Operating frequency: 32KHz
PE Cell
Range <5 lux to >5000 lux (reflected)
Automatic “Daylight Harvesting” mode
Infra Red Remote Control Receiver
Range up to 6m
LED activation indicator
Can be used with DTK500 series infra red remotes
or other learning IR remotes controls
Controls
Walk test/ LED indicator
Service switch
Control IO
Serial Port
– RS485 Dynet 80mA
Terminals
Standard:
5 way removable terminal strip, 1 x 2.5mm2 max
conductor size
Operating Environment
0
o
C to 40
o
C ambient temperature
0% to 90% RH non condensing
Dimensions
90mm diameter x D 26mm
Weight
Packed weight 0.25kg
Compliance
CE, C-tick
