52
EN
52
EN
DV DUBBING
DVC to VCR Dubbing
Before recording from DVC, refer to page 48 for
connection instructions.
Note for DV dubbing
• With regard to DVC to DVD dubbing, if you press
[PAUSE
F
]
at step 5, the tape will rewind to the point a few
seconds preceding the paused point when you press
[OK]
at step 6, then, it will start dubbing when it comes to
the paused point.
• The unit does not send out the output signal to DV camcorder.
• For the proper operation, connect DVC to the unit directly. Do not connect this unit and DVC via any other unit.
• Do not connect more than one DVC.
• The unit can only accept DVC. Other DV device such as cable / satellite box or D-VHS VCR cannot be recognized.
• If no video signal is detected from the DVC during DVC to DVD dubbing, the recording will be paused and “
I
” will
flash on the TV screen. The recording will resume when the unit detects the video signal again.
• When the DVC is in Camera mode, refer to “Guide to DV and On-Screen Display” on page 50.
• You cannot dub from DVC to the both DVD and VCR at the same time.
• You cannot change the output mode during DVC to VCR dubbing. If you want to switch to the DVD mode, stop
the VCR first.
• During DVC to VCR dubbing, you cannot change channels while paused.
• When output is in DVD mode while playing back a DVD using E3(DV-IN), you cannot switch to the VCR mode.
• If you are using anything other than E3(DV-IN) to playback DVD, you can switch to the VCR mode, but cannot
select E3(DV-IN) channel. (You can select E3(DV-IN) after switching to the DVD mode during VCR playback.)
• You cannot dub from DVC during timer standby mode.
• During timer standby of either component, you cannot select E3(DV-IN) even on the component which is not in
timer standby.
• Date / time and cassette memory data will not be recorded.
• Pictures with a copy-guard signal cannot be recorded.
• A DV terminal is a terminal that can use the transmission mode conforming to the IEEE 1394 standards called “Fire
Wire”. It enables digital dubbing between DV devices with little degradation.
1
Repeat the steps 1 and 2 on page 51.
2
Press the PLAY button on your DVC
to find the point where you wish to
start dubbing. Then, press the PAUSE
button on the DV camcorder when
you come to the desired start point.
3
Press [REC
I
] to start recording.
4
Press the PLAY button or the PAUSE
button on your DVC to resume the
playback.
The dubbing will start.
To pause the recording:
Press
[PAUSE
F
]
once.
“REC” will flash.
To resume recording:
Press
[REC
I
]
or press
[PAUSE
F
]
again.
“REC” will reappear.
5
To stop recording, press [VCR] then
press [STOP
C
].
Press [VCR] first.
Preparing for DV to VCR dubbing:
• Insert a recordable cassette tape and make sure your
DVC is in video mode.
