Software upgrade
A. Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: _____
(No need the label name)
File System:
ISO9960
File Name:
DVDR3408_93_V*.CUB
Remark: “
*
” stand for the upgraded version number
Note: It is required capital letter for the Label name
& the File System name.
2) Burn the data onto a blank CDR
B. Procedure for software upgrade:
1) Power up the set and insert the prepared Upgrade
CDR.
2) The set will start reading disc & response with the
following display on TV screen:
Software upgrade disc Detected, select OK to start
upgrading or CANCEL to exit.
Press OK button to start.
3) After press <OK> button to confirm, then screen will
display:
Upgrading software, please wait. Do not switch off
the power……
Please wait patiently, approximately two minutes
later the upgrading will complete.
4) The tray will automatically open when the upgrading
complete, and the TV will display:
System is successfully upgraded, Remove disc
from the tray and reset system.
5) According to the TV direction, take out the disc and
press OK, the tray will close, Reset the system.
C. Read out the software versions to confirm upgrading
1) Power up the set, Keep no disc in disc tray and the disc
door closed.
2) Press <0><0><0><9> <OK> button on remote control,
then the software version and other information will be
shown on the TV screen as follows:
Build: DVDR3408_93_VXX
Date: XXXX XX XXXX
Loader Version: XX.XX.XX.XX
Region Code: XXX
Region Code, Software Version& Upgrades
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
3-1
http://www.jdwxzlw.com/?fromuser=华盛维修
家电维修资料网，免费下载各种维修资料
