EN 12
3139 785 31500
Upgrade Software & Repair Chart
5.
5. Firmware upgrading and HDD Formatting
Important
Instructions
• Each of the 3 Upgrade procedures has to be recorded into 3 separate discs.
•
The
FLASH
fi
rmware and HDD
fi
rmware must be matched (i.e. Same version no.)
•
FLASH
fi
rmware upgrading must be done before HDD
fi
rmware upgrading.
5.1 Firmware
Upgrading
A. Preparation to upgrade
fi
rmware:
1. Unzip the zip-archive
fi
le
2. Start the CD Burning software and create a new CD project (data disc) with the following settings:
File
system: Joliet
Format:
MODE 1: CDROM
Recording mode:
SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD
Note: Long
fi
le name is necessary for the preparation of the upgrade disc
3. Place the content of the zip-archive into the root directory of the new CD project.
4. Burn the data onto a blank CDR or CD-RW
B. Procedure to apply the FLASH
fi
rmware upgrade:
1. Power up the set and open tray.
2. Insert the prepared Upgrade CDROM and close the tray,
3. The TV connected to the set will display:
Software Upgrade Disc detected
Select OK to start or CANCEL to exit
4. Press <OK> button to con
fi
rm upgrading (use left/right button for selection)
5. The TV connected to the set will display:
Upgrading Software, Please wait
Do not switch off the power
The whole process takes less than 5 minutes.
Note: Do not press any button or interrupt the mains supply during the upgrading process, otherwise the set may becomes defective
6. When the upgrading process is successful the tray will open and the TV connected to the set will display:
System is successfully upgraded.
Remove disc from tray & reset system
7. Remove the Upgrade Disc and press <OK> button to con
fi
rm
8. The TV screen goes blank, tray close and after a while the Philips Logo screen appear again.
C. Procedure to apply the HDD
fi
rmware upgrade:
1. Power up the set and open tray.
2. Insert the prepared Upgrade CDROM and close the tray,
3. The TV connected to the set will display:
Software Upgrade Disc detected
Select OK to start or CANCEL to exit
4. Press <OK> button to con
fi
rm upgrading (use left/right button for selection)
5. The TV connected to the set will display:
Upgrading Software, Please wait
Do not switch off the power
The whole process takes less than 5 minutes.
Note: Do not press any button or interrupt the mains supply during the upgrading process, otherwise the set may becomes defective
6. When the upgrading process is successful the tray will open and the TV connected to the set will display:
System is successfully upgraded.
Remove disc from tray & reset system
