D
IAGNOSTICS
17
English
Diagnostics
Fault
Possible cause
Remedies
Device does not start
Short-circuit in the antenna cable or
low-impedance antenna with simultane-
ously active antenna power
Check antenna cable
Remove antenna cable, start receiver and
set option
active antenna
to
OFF
, see
p. 10
No mains voltage
Check connector cable and pluggable
power supply
No picture, no sound
No mains voltage
Check connector cable and pluggable
power supply
No channel list or incorrect channel list
Carry out automatic channel scan, see
p. 10
Short-circuit in the antenna cable
Switch device off, eliminate short-circuit,
switch device on
Defective or missing cable connection
Check all cable connections
Antenna badly adjusted
Readjust antenna
Lost connection, or cable too long
Check connection, shorten cable length
No picture or bad picture
Antenna too small
Use bigger antenna
SCART plug not completely connected
Check SCART connection
Antenna badly adjusted
Readjust antenna, see p. 13
Passive antenna does not offer enough
power
Use active antenna and switch on via the
main menu, see p. 10
Channel is broadcasted by means of
other parameters
Carry out automatic scan mode, see p. 10
Sound available, no picture
Antenna badly adjusted
Readjust antenna
Channel is broadcasted by means of
other parameters
Carry out automatic scan mode, see p. 10
SCART plug not completely connected
Check SCART connection
No reception of channels
that could be received
before
Channel is no longer broadcasted
Not any
Disturbance by DECT telephone
Increase distance between device and tel-
ephone
Antenna badly adjusted
Readjust antenna
Remote control does not
work
Obstacle between remote control and
receiver
Eliminate obstacle
Faulty data stream -> device locks
Disconnect pluggable power supply, re-
establish connection after 10 seconds
Device is not switched on
Switch on device
Batteries are empty
Insert new batteries into remote control
Several channels are not
received from time to time
These channels are not broadcasted 24 hours a day and sometimes are not available. This
does not resemble a fault.
Device cannot be operated
Obstacle between remote control and
receiver
Eliminate obstacle
GB_Anleitung_Philips_DTR200_Englisch.book Seite 17 Montag, 24. Oktober 2005 10:47 10
