Getting started
10
Install
3.3
Press
B
on the remote control and wait a few
seconds to switch the receiver on.
The receiver is on: the LED is green.
The receiver is in standby mode: the LED is red.
During a software loading: the LED is blinking.
At the
fi
rst installation, the
First Time
Installation
window appears:
Highlight the
Country
fi
eld using the arrow
key .
Select the desired language using the arrow
key or .
Note
Read the information messages displayed on
the screen. They will help you to set the correct
values.
Highlight
Postcode
using the arrow key .
Press
OK
and enter your postcode.
Then successively set the desired values. In
doing so, observe the following:
By using the arrow key
•
or , you switch
between the individual setting possibilities.
By using the arrow key
•
or , you change
the displayed values.
•
Then highlight the
OK
fi
eld using the arrow
key , and press
OK
.
The
Automatic Search
window is displayed:
If desired, change the values for the
Start
and
End Frequency
using the arrow key
or .
Note
The displayed values for the
Start
and
End
Frequency
can normally be maintained.
Using the arrow key or , you de
fi
ne the
channels to be searched for:
All
channels or
channels that are
Free to air
only.
Then highlight the
OK
fi
eld using the arrow
key , and press
OK
to start the channel
search.
The window displayed provides information on
the progress of the channel search.
Note:
By pressing
EXIT
, you can stop the scan mode
at any time.
