Upgrade WAS700 Station:
6. Press
STANDBY-ON
to turn on WAS700 Station
→
Upgrading starts automatically
→
The display shows “
Updating firmware, please wait……
” .
A progress bar appears
→
Station will reboot itself twice during the upgrading process
→
After about 5 minutes, Station returns to HD mode. The upgrading is
completed
(Note: - Keep your Station turned on during the upgrading.)
Helpful hints:
-
To check the firmware version, see Preparation: Verifying firmware
version.
- If you have any problem, see
troubleshooting
.
__________________________________________________________________
5. Troubleshooting
If the Station’s display shows: "
Firmware is damaged, restoring a new copy …
"
or "
Center is connected, retrieving firmware
"
Follow the DON’T below:
a.
DON’T restore Center’s setting
(Don’t select "Menu"
→
"Setting"
→
"Restore Setting" on Center)
b.
DON’T delete Stations
from Center (Don’t select "Menu"
→
"Station Mgnt"
→
"Delete Station" on Center)
c.
Do NOT change Center’s Wi-Fi setting
Then,
1. If the progress bar is moving on, wait and upgrading will start later on the
Station
2. If the progress bar stops moving and/or Station’s display shows "
Error Code
xxx
", turn off the Station and then turn it on.
3. If Step 2’s problem still exists, check there is no Wi-Fi interference around and
reduce the distance between Center, Station and Wireless router/Access Point
(if applicable)
__________________________________________________________________
