2-1
CS 46 663
SERVICE HINTS
REPAIR POSITION COPPERSIDE
To get access to the copperside of the
printed board assembly proceed as follows:
1. Remove the bottom screws (6x)
2. Lift the bottom-cabinet
3. Supply the unit via external DC-socket
4. Take care that the door switch is closed during
measurements
To get access to the componentside of the
printed board assembly proceed as follows:
1. Remove the bottom screws (6x)
2. Open the CD-door
3. Lift the top-cabinet and put it backwards on the table
4. Supply the unit via the external DC-socket
5. Take care that the door switch is closed during
measurements
REPAIR POSITION COMPONENTSIDE
DISMANTLING THE CD-DOOR
To dismantle the CD-door proceed as follows:
1. Disconnect the membrane keyboard
(flex-foil connector on copperside of printed board)
2. Smoothly bend the bridge of the cabinet downwards as
shown in
1
. Take care not to touch the lens
3. Smoothly pull out the right hinge of the CD-door as
shown in
2
.
4. Lift the CD-door
Remark: Do not use screwdrivers or tools like that.
Sharp edges could damage hinge or cabinet part.
