POWER SUPPLY
5
Whenever convenient, use the mains supply if you want to
conserve battery life. Make sure you remove the mains plug from
the set and wall socket before inserting batteries.
BATTERIES (NOT INCLUDED)
1.
Open the battery compartment and insert 8 batteries,
type
R-20
,
UM-1
or
D-cells
, (preferably alkaline) with the
correct polarity as indicated by the "+" and "–" symbols inside
the compartment.
Remote control (supplied for AZ 2025 model only)
Open the battery compartment and insert two batteries,
type
AAA
,
R03
or
UM4
(preferably alkaline).
2.
Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
–
If
BATT LOW
lights up, battery power is running low.
– The
BATT LOW
indicator eventually goes out if the
batteries are too weak.
Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
•
Do not mix battery types:
e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
• When inserting new batteries, do not try to mix old batteries
with the new ones.
• Remove the batteries if the set is not to be used for a long
time.
•
Batteries contain chemical substances, so they should
be disposed of properly.
Using AC POWER
1.
Check if the mains supply,
as shown on the type plate
located on the bottom of the set,
corresponds to your local
mains supply. If it does not, consult your dealer or service
centre.
2.
If your set is equipped with a voltage selector, adjust the
selector so that it matches with the local mains.
3.
Connect the mains lead to the wall socket and the set is now
ready for use.
4.
To disconnect the set from the mains supply completely,
remove the mains plug from the wall socket.
AZ 2025/00
page
5
8 x R20 • UM-1 • D-CELLS
MAINS ~
English
